De just put me on TRT

[viperspike]

I heat a coffee cup of hot water in the microwave for about 1:20 sec, or until its pretty damn hot. After I draw my injection I recap the needle and submerge the 1ml syringe in the water until I'm ready to pin. This is way quicker and more efficient than running the syringe under water as I can keep it hot until moments before I pin. Next I dry off the syringe and remove the needle w/ cap that was in the water and replace with a 27G that is sterile. I've noticed if you draw into the syringe too quickly it will crash the Test and form small bubble looking objects in the syringe. Even after doing this, heating it up in a cup of hot water returns it to solution and makes for a pain free pin.

 

[MotorCityMuscleMachine]

I heat a coffee cup of hot water in the microwave for about 1:20 sec, or until its pretty damn hot. After I draw my injection I recap the needle and submerge the 1ml syringe in the water until I'm ready to pin. This is way quicker and more efficient than running the syringe under water as I can keep it hot until moments before I pin. Next I dry off the syringe and remove the needle w/ cap that was in the water and replace with a 27G that is sterile. I've noticed if you draw into the syringe too quickly it will crash the Test and form small bubble looking objects in the syringe. Even after doing this, heating it up in a cup of hot water returns it to solution and makes for a pain free pin.

Yes, this would work quite nicely too,. & Probably pretty hot compared to tap.water,. But my tap get pretty hot. Enough to change the viscosity of the inject that's for sure

 

[C587]

Cant believe I've never tried this until last night. Made the injection take about 30 seconds as opposed to 2-3 minutes.

 

[Joesmoke]

Works like a charm for me. Especially as the weather get cold the oil thickens in the vial.